Multiplex Easy Glider Pro almost ready to fly Sailplane.
FEATURES:
-
Elapor foam to resist damage
-
White in color
-
Wings: Two piece with fiberglass wing joiner
-
Spinner: Elapor foam 2.2" (55mm) diameter
-
Aileron Control: Dual servo
-
"Full House" Control Surfaces: Elevator, Rudder and Ailerons
INCLUDES:
-
One (1) Multiplex Easy Glider Pro with decal sheet, foam spinner, wing joiner, pushrods, hardware and illustrated instruction manual
REQUIRES:
-
Radio System: 4-channel (min) with micro receiver
-
Easyglider Pro Tuning Set: MPX332650
An outstanding power set for the experienced, demanding RC pilot. Current drain with 2S LiPo and supplied propeller: approx. 32 A.
-
Servos: Two (2) micro size for elevator & rudder Two(2) nano size for ailerons
-
Servo Extensions: Two 16" (200mm) for aileron servos Y Harness: For aileron servos
-
Battery: at least 2100mAh
-
Battery Charger: LiPo compatible
If building as glider only the following items are required;
-
NiMh Receiver Battery (at least 1800mAh)
-
Switch Harness with Charge Jack
-
Launching Kit
SPECIFICATIONS:
-
Wingspan: 71" (180.3cm)
-
Length: 43.7" (112.3cm)
-
Flying Weight: 28.5oz (810g) with standard power system
-
Wing Loading: 6.5 oz sq ft (20 g sq/dm) with standard power system
-
Wing Area: FAI approx. 226 sq in (41.6g/sq dm)
-
Airfoil: Semi symmetrical
-
CG (centre of gravity): 2.7" (70mm) from leading edge at wing root
-
measured at fuselage side
Additional Info:
This model is NOT made of styrofoam and it is not possible to glue
the material using white or epoxy glue. Medium C.A. glue used with an activator is the only method of gluing recommended by the
manufacturer.